(800) 853-2651
SHOP NOW

Recent content by bullfrogbill

  1. B

    TO-20 Tractor steering oil seals leak

    My to-20 was leaking also. Several years ago there was a post on this site. The poster said to grind foundry casting off of fat part of control arm, that way you slide seal on and off. That is what I did on mine. I don t remember but when you get old seal there mite be a part number on it. I...
  2. B

    135 diesel stopped running

    thanks for the replies. Going to have to make the trip to work on it again. Engine didn t overheat and still has compression. The air filter was the first thing I changed,also checked rubber hose to manifold. No mice. Guess I ll start at fuel tank, check the strainer. May be clogged. Couldn t...
  3. B

    135 diesel stopped running

    1965 Massey 135. Did about 2 hours worth of mowing at 1750 rpm. Tractor ran fine, headed to shade tree to let engine cool down. Put throttle to idle, tractor shut off. Tried to get it start no go. Changed fuel filters , made sure gaskets were in housing grooves. Still no run. Tried pulling to...
  4. B

    135 diesel stopped running

    I ll have to do more checking. Tractor is 200 miles away. Have owned it for 4 years. Only battery problems,always starts right up. I feel it is something simple I hope. Guess I have to get the old TO-20 back out. Thanks for the reply. I ll be back.
  5. B

    135 diesel stopped running

    1965 Massey 135. Did about 2 hours worth of mowing at 1750 rpm. Tractor ran fine, headed to shade tree to let engine cool down. Put throttle to idle, tractor shut off. Tried to get it start no go. Changed fuel filters , made sure gaskets were in housing grooves. Still no run. Tried pulling to...
  6. B

    135 diesel stopped running

    id not try cracking lines at injectors. For some reason I suspect the lift pump. Noticed when try to bleed air bubbles showing up in sediment bowl. Don t know if that s normal. Bleed screws at the pump we got air then stream. If lift pump quit working while mowing would injection pump get enough...
  7. B

    TO20 Hydraulics

    no one has mentioned that you can loosen the 4 bolts that hold the quadrant to the top cover, then it can be moved forward. Had this happened, forgot to to tightened the 4 bolts, nothing worked.slid forward tightened bolts, perfect!
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top