(800) 853-2651
SHOP NOW

Recent content by carolina oliver

  1. C

    new flower pot well maybe?

    Looks WAY to nice to waste,.. I don't need but someone does. Post your location please.
  2. C

    Bosch Pump oliver 77, 88 diesel

    Thank you Dieseltech. Does anyone reading this out there have or knows where to look for this pump? TIA
  3. C

    Bosch Pump oliver 77, 88 diesel

    A friend working on an Allis WD45 Diesel. Pump bad, was told Oliver used same pump on 77 and 88. Is this true and does anyone here have one for sale. Closer to NC the better. TKS
  4. C

    77 gas into 1550 D governor control

    Putting a 77 gas into 1550 was D. Having trouble getting throttle linkage to work governor correctly.. Starts and idles fine but my linkage doesn't get governor to open throttle in carb correctly.. Anyone here w/ linkage length might help me. TKS in advance.
  5. C

    Looks like I'm an Oliver man now

    Congrats: I've got a 1655D that Dad bought new in mid '70s. My main Big Tractor now. Do my heavy mowing, etc w/it.. Very dependable.
  6. C

    1550 engine

    Looking for replacement engine: 1550. could use 77, Super 77, 1550, 1555. Prefer Diesel but gas ok.. NC. Tks.
  7. C

    Ford 300 in Super 88

    This should be a fun/not fun project but good luck. FYI, I have a friend building a Henry J drag car, using a 300 Ford, REALLY built! but planning bout 700 hp non-turbo! Enjoy
  8. C

    Using power beyond for a single action cylinder?

    Guys, I put a power beyond valve, meant for a front end loader, had one function on joystick that had float, onto my 1655. Float feature works perfectly. Plumbed up according to a pic/recommendation from this site. Three point hitch works fine. This is a can do operation.. Good luck..
  9. C

    Power Steering Hoses Oliver 1600

    Suggestion: While in there do all hoses, PLUS take plenty of pics to be sure you replace correctly.
  10. C

    1600 clutch

    I'm certainly not the expert here, but lots of us have done this to keep the sprockets lined up: apparently was done in factory on some although not on my 1655 or 2-70: Drill a 5/8 or 1/2 in. hole in bottom of tub under back side of 2 speed or 3 speed as you have. Run a bolt w/ locking nut...
  11. C

    1650 Acts Like Running Out of Fuel

    Interesting note on fuel cap not venting. I actually run the IH type caps on all 4 of my 4 digits. Put a new one on my 1550. Keeps fuel from leaking all over hood.. BUT: first time I ran it for hour or so.. acted like out of fuel.. Took cap off to check tank, had a vacuum there so now...
  12. C

    Oliver tedder

    99.9% if all tedders have been/ are built in Europe. Even the few built in US are mainly European components. In fact, Kuhn built horse drawn tedders in France in the 1800's
  13. C

    Hydraulic drive gear for 1550 needed

    Brad did not have one.. Justin checking on the 2-70 he is parting out.. TKS for the replies..
  14. C

    Hydraulic drive gear for 1550 needed

    Friends, repairing hydraulic pump etc on 1550. New pumps require the drive gear in transmission be from any 16xx tractor. Any of yaw have such avail? TIA.
  15. C

    JX85 Clutch

    Fellas,, fixing to need likely replacement on my JX85 clutch. Dry Clutch, mechanical reverser. Cab/4wd/loader. Hay tractor that runs baler also. 900 hrs mostly by me and I am easy on it.. Previous owner maybe not so careful. Plan to take apart, replace. What recommendations you have...
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top