(800) 853-2651
SHOP NOW

Recent content by IH400

  1. JD 730 diesel Pony start
    Expired

    For sale JD 730 diesel Pony start

    Original, run like new and everything works. Have original owner manual with notes from original owner. Has new tires on front, back tires are good but a few years old. Has JD top link, wf, flat finders. pony was gone thought last year. Does not use oil or has any blow by.
    $8,500.00
  2. I

    3020 starter

    Its 12 volt.
  3. I

    3020 starter

    A few month ago I bought a 1964 3020 diesel. The tractor had been overhauled by a JD dealer. They put a new started and batteries in it. The problem is the starter grinds bad when it kick in ( it does go ahead and start the tractor good). I check the flywheel and it looks good. The starter is...
  4. I

    730 Tack

    I have a 730D that the RPM needle has quit ( it bounces but does not lock in) you can hear the gears grind , the hour gauge is still working. Does anyone know if you can get a kit to replace the gears for the RPM needle. The tack is original and the hours are correct, which I would like to keep...
  5. I

    730 pony

    The pony on my 730 will not RPM up. It will start and run good in the start position but when I move it to the run position it will start to speed up than start to die, it does not complete die but will not get up to speed like it should. It will not turn over the big motor if it is hot. Could...
  6. I

    super 77 clutch

    My super 77 clutch will not disengage. The tractor run great about 3mo ago, but now you have to start it in gear and shut it off to get it to stop. Is there a service port or do I have to take the cover off to get the clutch lose? If I have to take the cover off, can that be done without taken...
  7. I

    400 diesel

    Thanks for all the info. I think my timing might be off as the tractor smokes a lot till it warms up, and then still runs slow. How hard is it to advance the distributor a little or to know the timing is set right? I also put new points in it and had a little problem getting the gap set right...
  8. I

    400 diesel

    Thanks for all the input. I think my timing might be off a little too, because it smokes a lot until it warms up. Which way do you tune the distributor to advance the timing? I put new points in it and I had trouble getting the gap on the points at the top. They might be a little wide. Would...
  9. I

    400 diesel

    Thanks, but mine idles so slow that the starter turns the motor over faster than when it is running, and it often stop when I let of the starter.
  10. I

    400 diesel

    Do you have to remove the carburetor to get the air valve? And I too cannot figure out which way to turn it or how much? Thanks for any help. Bill W
  11. I

    400 diesel

    I have a 400 diesel that idles very slow on gas, about 500 RPM. How do you get it to idle faster without a throttle? Thanks for any help anyone can give. Bill W
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top