(800) 853-2651
SHOP NOW

Recent content by jrh009

  1. J

    Safety Instructions For Paint Hardner Sold on This Side

    A couple of years ago I got some advice from my Internist, also Chief of Staff at our local hospital and a casual friend of mine after I mentioned my restoration project and hardeners. My wife was also there as it was at a social event. When we got home that was the end of partial protection...
  2. J

    Anyone know PPG Omni Code for Ford 850?

    Here are the Omni paint codes, I would mix as per the manufacture's spec at 4.1.2. I found too much orange peel using 4.1.1.
  3. J

    Omni Question and HVLP Setting

    The Omni data sheet sheet says 4.1.2 for mix ratio. My supplier said to use 4.1.1. I managed to shoot some red without too many issues, but I have major orange peel issues with the grey. I am guessing the mix ratio is the problem. Should 4.1.2 be used. the paint is single stage 2.8, MTX...
  4. J

    Anyone know PPG Omni Code for Ford 850?

    I spent a lot of time on this for my 641, not sure if the colours are the same or not for the 641 and 850. I did not want the orangey colour so used the vermillion. The original vermillion is not available as it had lead in the mix, I have an Omni code for a replacement that is almost a...
  5. J

    640 Differential cover

    Thank you, going shopping.
  6. J

    640 Differential cover

    What is this document, I have 2 different manauls but they do not include part numbers
  7. J

    Paint Code

  8. J

    Paint Code

    I need help with "Ford Tractor Red" which at one time I believe was/is Vermillion. In 2012 I had paint mixed for me , a single stage urethane, one qt was Shop Line and the other qt was Value Pro, they matched identically. The paint code is DT3272. The problem is that the supplier I used...
  9. J

    Paint Code

    Yes you are absolutely correct, the original colour was the "orange red", it was under the red paint when I started to strip the paint off. The previous owner painted over the original paint. I didn t like the orange tint, so went to the older "Vermillion" which may have been an 8N colour...
  10. J

    Paint Code

    Wow, thanks for the help, yes you are correct. I have the Chrysler/Dodge DT3272. 70075, on the can that they mixed. Beats me why they couldn t call their tech rep at their supplier. I ll follow up with the ACE039 911721. and the Motorcraft service part number. Hopefully one of those...
  11. J

    Mini HVLP

    Sounds like it would be easier for me to use the 1.4 gun, keep the recommended mix ratios and waste a little bit more paint. Too much effort cleaning the parts and prep work then to be worried about using a little extra paint. Thank you
  12. J

    Mini HVLP

    The parts are cast, so finish is not critical, I m getting to the point of needing to start painting. The shop line spec recommends 1.4. Nice to save product if I can. Thanks for the response.
  13. J

    Mini HVLP

    I have a mini gun with a .8 mm tip, I want to apply some PPG epoxy primer. Is this a waste of time. I do have regular HVLP gin with a 1.4, but I am just doing parts and wanted to spray lower volumes. Gun is a Power Fist sold in Canada by Princess Auto, cheap gun and no loss if it is useless.
  14. J

    Driving shed moving

    Remember that pole structures develop wind resistance by bending moments in the poles. This is obtained by burial depth related to the soil strength. So if you are going to cut off the poles and anchor them onto a conventional foundation the contractor will need to design a moment connection...
  15. J

    Storage of cleaned parts prior to painting

    I am in the same situation, working on restoring a 641 Ford with no time window. I use electrolysis to clean the parts but need to store them before getting enough parts to prime and paint. I use Picklex 20, have at the moment 10 to 15 parts cleaned with Picklex on them for 8 months. The...
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top