(800) 853-2651
SHOP NOW

KettingbyBOB's latest activity

  • K
    KettingbyBOB replied to the thread dying 1020.
    Hi Folks, thought I would update: I messed with distributor cap because two terminals looked burned, so I sanded them and rotor flange...
  • K
    KettingbyBOB reacted to JIM MN's post in the thread dying 1020 with Like Like.
    Did the points GAP change again?? Put the old condenser back in distributer?? Is the gas shut-off under the gas tank clear open...
  • K
    KettingbyBOB replied to the thread dying 1020.
    Yes, things can be frustrating. Calling for snow on tue/wens so after that I will try these suggestions first with blowing out fuel...
  • K
    KettingbyBOB reacted to Fixingfarmer's post in the thread dying 1020 with Like Like.
    Big hose over little line into pail. Or keep testing it on the left side like you have just put it back together till it’s the last...
  • K
    KettingbyBOB reacted to rrlund's post in the thread dying 1020 with Wow Wow.
    Be careful fooling with that lift pump. I took the line off mine one time and cranked it over to see if it was pumping, and it sprayed...
  • K
    KettingbyBOB reacted to used red MN's post in the thread dying 1020 with Like Like.
    Hello Bob, welcome to YT! In the link look at part 18, it is the elbow where the line from the pump connects. There is a fine screen...
  • K
    KettingbyBOB reacted to Jim.ME's post in the thread dying 1020 with Like Like.
    The fuel solenoid only shuts off fuel going through the main (load) jet. It does not shut off fuel going into the carb fuel bowl...
  • K
    KettingbyBOB reacted to Fixingfarmer's post in the thread dying 1020 with Like Like.
    Yes most 20 series have one and Jim has confirmed it does that's probably the place to start it sounds like to me. Checking that the...
  • K
    KettingbyBOB reacted to Fixingfarmer's post in the thread dying 1020 with Like Like.
    condition of that pump then. a little more difficult to test but the 100 feet and idle all day long leads me down the fuel path quicker...
  • K
    KettingbyBOB replied to the thread dying 1020.
    No. I did not realize it was there on side of coil till I took it off, Thanks. Jim, it acts like it runs out of fuel, that is why the...
  • K
    KettingbyBOB posted the thread dying 1020 in John Deere.
    My '67 1020 3 cyl gas will start right up and idle. Take it out of barn, runs for 100 yd and quits. Then it's restarting it every 2 ft...
Show older items
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top