(800) 853-2651
SHOP NOW

Recent content by RBnSC

  1. RBnSC

    Brand new 1983 555 - Well, new to me...

    I had a 555B the bucket controls were very tight and stuck similar to yours. once we got the stick to move it was hard to center. If I remember correctly we kept spraying penetrating oil on it till it loosened up. The steering cylinders were usually the leaking culprit. Ron
  2. RBnSC

    Shouler pain

    Went to an orthopedist for the first time last month. My neck and shoulder were bothering me so badly. X-rayed me and I waited an hour for the doctor to talk to me. When he walked into the room I could see in his face a look I had seen before. When you look at a tractor that is just not worth...
  3. RBnSC

    Ford 601 differential numbers

    You might consider finding a rear axle from an 801 or a 4cyl 4000. A little heavier and stronger and will bolt right in. I happen to have an extra one if you live on the east coast.
  4. RBnSC

    Test

    Just an old bottle picture.
  5. RBnSC

    Nice Farmall A

    That looks like a keeper. Ron
  6. RBnSC

    Ford 172 diesel squealing noise, no oil pressure, loose harmonic balancer bolt, and white smoke out of breather

    The brackets for the tank are different also. Ron
  7. RBnSC

    Ever try to sell used disc blades?

    Bought a good many. Ron
  8. RBnSC

    Jimmy buffet test

    Test
  9. RBnSC

    Smoking 8N

    Four years! It sure takes you a long time to listen to good advice! Ron :ROFLMAO:
  10. RBnSC

    Jimmy buffet test

    Test
  11. RBnSC

    John deere 544 B engine to trans u joint replacement

    My boss has a 444B when we had to put joints in that shaft my fellow worker had to crawl under and up to get his short, thin, wirey self under there to get to it. If I remember correctly I had to direct him through a spot I could barely see what he was doing. It wasn't easy and I was surprised...
  12. RBnSC

    Average age of user

    67
  13. RBnSC

    Jimmy buffet test

    Test
  14. RBnSC

    Chevy 'crump' update

    How about a wheel bearing? Our 2004 Tahoe made a rumbling sound when turning left. Bad wheel bearing.
  15. RBnSC

    How did you hurt your self this week

    I bleed like crazy for the same reasons. One day I was in the shop checking out a tagalong trailer. I had drill sitting on the fender. Leaning over my head touched the drill bit and made a little scratch right in the hairline of my forehead. I'm checking the wheel bearings and sweating when the...
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top