(800) 853-2651
SHOP NOW

Recent content by Robert Kies

  1. R

    3020 Rockshaft Linkage

    Thanks for the suggestions. I have it wired on now but was looking for something a bit more permanent (maybe that is). I was hoping the pin just screwed out. I don't think of using a pushnut. I'll give that a try. This post was edited by Robert Kies on 02/05/2022 at 08:29 am.
  2. R

    3020 Rockshaft Linkage

    Hello, I have a 68 3020 where the pin on the lever that works the rockshaft is worn to the point that the snap ring pops off. The parts diagram shows that this pin is replaceable, is that correct? Or is the pin and lever a single unit? Thanks
  3. R

    3020 hydraulic pump drive

  4. R

    3020 hydraulic pump drive

    Tips on getting them loose? I have been hitting them with penetrating oil for the past couple weeks. Picked up the parts and will replace today. Not a whole lot of room to move. I've had the tractor about 8 months now. First new gen I've owned.
  5. R

    3020 hydraulic pump drive

    Mark, that's the kinda advice I'm looking for. Thank you. Little tips and tricks you pick up from experience to make the job go easer.
  6. R

    3020 hydraulic pump drive

    Thanks for the advice on the screws. I'll leave 'em be.
  7. R

    3020 hydraulic pump drive

    I have a 68 3020 gas syncro that needs the bushings replaced on the hydraulic pump drive. In the parts list, it looks fairly straight forward, remove a couple of bolts, remove the clamps, bushings and screws and replace with new. Also, looking at the drive, there isn't much room there to...
  8. R

    51 A needs re-wiring

    Thanks, I'll be getting a new wire harness.
  9. R

    51 A needs re-wiring

    I need to replace all the wiring. Is there a best wire to use? There is currently a mix of original and newer wire on the tractor. The newer wire is plastic coated and cracked. Thanks.
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top