(800) 853-2651
SHOP NOW

Search results

  1. A

    Vintage tractor hauler - F-700

    I'm looking at a '68 F-700 flatbed as a toy to haul tractors to shows. It has a 390 v-8, 5 speed manual, and 2-speed rear-end. Would that be an automotive bell housing on it or a SAE-2 or SAE-3? I recently came across a DT360, and had a wild idea that it might make a good re-power for such...
  2. A

    WD9 - Thermostat or no?

    On to the next issue with the Fatman. He doesn't have a thermostat, and takes a long time to warm up. I can see the water churning in the radiator tank when running right after startup. No bubbles. Ran him about 10 minutes while greasing my 7 foot bush hig mower and putted out in low gear...
  3. A

    Radiator hoses for WD-9

    Does a hose kit for an Md / wd6 fit a wd9?
  4. A

    VR or cut out relay on my WD-9

    I was under the impression I had a cutout relay o.n my tractor. I have the 4 position light switch LHDB: But the guts loock a lot more complicated than a cut iut relay. The wire coming in to the top has batt voltage, and the wire coming in to the bottom is from the arm on gen. Field on...
  5. A

    What a WD-9 owner doesn't want to see.

    Well, I finally got my WD-9 running, after 2 years, 1 of over-work and 1 of health problems. Got a re-built mag, and all the finicky switchy stuff working, and fired it up this afternoon. The rack was stuck, but just a little patience got it to move and I was able to switch over to diesel...
  6. A

    450 Head on a Super W6

    I have a SW6 that the PO installed a 450 LP head on. Evidently the Super's used the same oil line as the regular M's to oil the governor. The 450 head does not have an oil drain port on the front to tie in to this line, so it is just open right now. I know for a fact it hasn't been run much...
  7. A

    Looking for a good mechanic in North Texas: Dubuqe models

    I have a 420 that is in need of more TLC than I feel confident I can handle. The rear wheel bearings are squealing, and I'm thinking about refreshing the engine as well. Can anyone recommend a mechanic that knows these beasties within a day's drive of the Dallas area? Thanks, Alan
  8. A

    1946 2N Axle question: super Seal or replace orginal seals?

    Hi guys. I'm restoring my wife's grandfather's 2N. It is pretty much a basket case. It will need all new front sheetmetal, a full rebuild on engine, TLC for the hydraulics, and I'm diving into the brakes. I don't have it apart yet, but was wondering whether y'all would recommend replacing...
  9. A

    is there a trick for oil filter gaskets?

    ...or is it just a ritual to sacrifice a quart of oil to the oil cartridge gods? I can NEVER get that little dude to stay in the groove on the first try!
  10. A

    350U LP -One week in - manifold issues

    The exhaust section of the manifold is cracked exactly in the center. Looks like it is all the way around and you could not have centered it better w/ a ruler and divider. The studs and nuts are a solid mass of rust. I'm going to try Naval Jelly and then Kroil to see if I can soak the nuts...
  11. A

    350U LP - How do I tell if it has been con to neg grd?

    Well, I've had the tractor a week, and only had time to start it once. I got the owner's manual in and saw that it was originally a positive ground system. The old battery sitting on it when I picked it up was set up Neg ground, so that's the way I wired my spare truck battery in. It...
  12. A

    Shiny new (to me) IH 350 LP Utility

    Hey, first post here. Just acquired a IH350 LP Utility, that appears to be in really great original condition. It appears to be in really great mechanical condition, and the sheet metal is good except for one ding on the "nose". As far as I know, it was bought new by a propane service company...
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top