(800) 853-2651
SHOP NOW

Search results

  1. K

    Kohler generator

    My dad has a trailer mounted Kohler generator bought used in the 80's that we powered a house with before permanent electricity was put in. I got it running again in the mid 90's and it has sat since. I'm sure I can get it running again but I question how it would effect newer electronics if...
  2. K

    5040 oil plug

    I must have lost the washer on the drain plug last time I changed the engine oil since it has had a slight drip for a while. Is it a copper or brass washer? I doubt it would have had an o-ring or did it? Thanks in advance. Keith
  3. K

    Antique tractors on Craig's list

    I still haven't figured out to post a link but there are quite a few unrestored antique tractors posted on Craig's list Houston. They are under farm and garden and located in the Conroe/New Waverly area. Looks like some pretty good deals.
  4. K

    Puma air compressor

    I am looking at a new air compressor. The one I am looking at is at Northern tool. It is a Puma Model #PK6560VS. I was wondering if anyone here has any experience with these. They seem to have good reviews online but here I can get real world information. I can't figure out how to make the...
  5. K

    Massey 130

    I have come across a 130 Massey with the Perkins diesel. It is S/N 385964. The battery cable shorted out and it caught fire. Where is the best place to find new parts for it?
  6. K

    AC 5040 steering leak

    I have an '84 model 5040 with a leak in the power steering at the valve that is on the end of the steering cylinder. It is leaking behind the boot where the nut is loose. I will be getting the tool to remove the arm and boot. Is there an o-ring back there? It also has a random leak where the...
  7. K

    5040 Electrical problem

    I have a 5040 that has a relay or voltage regulator that is smoking. It is on the firewall. If I disconnect the brown ground wire on the mount it quits smoking but the voltage jumps to 16v at the battery. I am assuming it is bad but not sure and if so where to get a new one.
  8. K

    AC 5040 shift lever

    I am replacing the transmission top plate and can't figure out how to get the shift levers out of the old top plate. They have 2 pins on either side and I dont know how to remove them. Any help is much appreciated.
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top