Search results

  1. M

    300 case oil level issue

    A friend has this tractor and been in the family since new. Has been sitting for years and years and wants to get it running. He recalls that his uncle parked it because the transmission fluid would keep filling the rear end with oil. The transmission fluid appears to be the hydraulic oil also...
  2. M

    F20

    Idles fine but can't throttle up. Just cuts out and stalls. Have gone thru the carb a couple times,can't find anything plugged.I can remove main jet and makes no difference. This tractor will start on the second or third crank.Help,any ideas!
  3. M

    Re: Antifreeze showing up in the oil of my Farmall M---what

    You got about three choices from where it could leak. Head gasket, cracked head,cracked block. I would remove oil pan and make sure radiator is full and pressurize the cooling system then watch for a leak from under. Maybe you can then isloate from which area the leak is coming from. Good luck
  4. M

    860 Pro shift handle leak

    Can the plate with the Pto handle be removed without much trouble. Got a bad leak around handle shaft
  5. M

    Ford 860 engine has a miss

    #4 cylinder will not fire. Changed plugs,swapped wires, plug fires laying against the block, checked compression, all four cylinders have 120 pounds compression but it does take #4 a few more revolutions to get to 120. Have spark,fire, gas but will not fire. Can pull wire off#4 and makes no...
  6. M

    Farmall cub crankshaft pulley

    Any special trick to remove the front pulley. Need to install a new seal. I made a puller to get as close to the shaft as possible,so as to not break the pulley on the outer diameter where the belt runs. Using a 5/8 thread rod for pulling and I got it so tight that it stripes the treads on the...

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top