(800) 853-2651
SHOP NOW

Search results

  1. M

    Super Major Injection Pump

    Yes rotate coupling 180 degrees Miles
  2. M

    Corragated Steel Pipe

    I have an older air seeder that uses 2in corragated pipe for the secondary uprights. Any sources? All new air drills/seeders use 2.5in Thanks in advance Miles
  3. M

    Looking '77 Loadstar 1800 with MV446 engine

    Need driver side exhaust manifold and ammeter guage. Any ideas where to find? I am located in SK Canada Thanks in advance
  4. M

    3-pt V-style snow thrower

    Does anyone have any tips/tricks to make heavy wet snow slide thru these better? The unit works perfectly when temps are less than 10 degrees F Thanks
  5. M

    Glass dimensions on Hesston 8100

    Does anyone know the dimensions of the (2) pieces of side glass for this unit. It is the same as Case 8820 tractor unit. Items 9 and 10 in figure below <a href="http://tinypic.com?ref=14bs1tc" target="_blank"></a> I would like to have glass cut locally before I drive out to farm which is 3...
  6. M

    OT - 41 Internation K3

    Buzzman The HD213 cannot be factory original in this model?
  7. M

    OT - 41 Internation K3

    I recently purchased an IH K3 sn # 4869 which I think is a 1941...and has an HD213 sn# 7763 engine. I have found oldIH and redpower websites but there isn't a lot of web stuff out there on these trucks 1. Any good sources of parts? 2. I have not found any K3 manuals to download or purchase...
  8. M

    4840 Oil leak at tach cable connection just above oil filter

    Thanks!
  9. M

    4840 Oil leak at tach cable connection just above oil filter

    Is there a seal in the there that needs replacing? I couldn't see anything in parts list. It has a fairly good leak right at the connector. OT - Where is the fuse block located? My flashers have stopped working. Thanks in advance.
  10. M

    Should my 4240 have enough horsepower to run JD 567 baler?

    Thanks in advance Miles
  11. M

    Hesston 8100 service manual

    Does anyone know where I can download OE manual? Thanks in advanced
  12. M

    Adjust slip clutch on Ford 980 mower

    Hi, I am getting slippage from this clutch on my mower...It looks like I need to turn the big nut. Can anyone please confirm...Thanks <a href="http://tinypic.com?ref=53pwr9" target="_blank"></a>
  13. M

    Case 1070 Hydraulics

    Thanks gentlemen! I hope that open-center hydraulics was a short lived design flaw and was fixed. I can't think of any positive reason why you would want this design. ...and there is no built in flow control... Miles
  14. M

    Case 1070 Hydraulics

    Hi I have a 1070 case with loader....under load the bucket lifts fine but drops quickly(free fall) when lowering. I can stop the drop with valve wheen lowering so it is fine. What is my problem? Miles
  15. M

    How do you polarize generator on MH 22

    There is no regulator - just a cutoff-relay One wire to field coils and other to relay Please advise
  16. M

    M-H 22GR8542

    The GR is Row Crop, Gasoline and 8542 makes it a '51 model
  17. M

    How do you polarize generator on MH 22

    My generator is not charging...How do you polorize generator on this model? Thanks in advance.
  18. M

    fenders

    are the fenders on a U 302 and jet star 3 super the same?
  19. M

    Got my MH 22 running and it sounds pretty good!!!

    ...but I need to change the u-joints on little drive shaft between clutch and transmission. Problem is that rear end shaft is seized on trans spline....I have used a lot of leverage but can't get it to release...and concerned that heat will fry the trans seal and front bearing. There is no...
  20. M

    Can anyone identify this rotiller?

    <a href="http://tinypic.com" target="_blank"></a> Thanks
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top