(800) 853-2651
SHOP NOW

Search results

  1. R

    Finally got the Gasboy pump primed

    I had made a thin paper gasket without any luck. Today while it was warm 55 degrees, I screwed out the anti ??? plug and pumped in alot of motor oil in the hole. Cranked and cranked , and here came diesel fuel all over my coat. Thanks guys for all your ideas. My MF 240 is now full and I...
  2. R

    How to prime a gasboy 1230 pump

    First thanks for the replies about my F150 pickup radio... I have a Gasboy model 1230 hand crank pump that has lost it,s prime. I has tryed pouring diesel fuel down the hose so fuel could get into the carbon wipes chamber. Then crank hard and fast, no luck. Then we took the pump apart ...
  3. R

    2014 ford 150 problem

    My f-150 clock is flashing and the radio and CD does not work. Happened about a week ago. Yahoo says this happens alott to older fords. Sounds like not an easy fix or a cheap fix. Anyone had this happen and how did you fix the problem? Robert in Md.
  4. R

    weather in Roanoke, Va March 16,17 18

    Wondering about the weather from the east to Roanoke Va. during the Winter IH show. Thanks Robert in Md.
  5. R

    Binks spray gun

    Guys, I,ve got a Binks Model 18 quart cup spray gun that I have used for years along with a lot of HF guns. I sprayed a gallon of Rustoleum SAfety Red on Tuesday and cleaned the gun as I have for years. On Thursday I tryed to spray again and air was blowing out the paint suction tube...
  6. R

    What is this?

    Friend gave this to me. It is about 24 inches long. It moves open and closed a little bit. No markings or writings. What do you think this is?
  7. R

    Ignition Resistor

    Just got a junk Super A that had been converted to 12 volt. Resistor wasn,t any good so we started the tractor without it. It started but I could tell when I checked for plug fire by moving the points that there was to much current. Purchased new resistor and checked the voltage coming out of...
  8. R

    MTD power washer

    I have a Troybuilt power washer made by MTD. The detergent tank fluid will not empty into the hose, I know I have to have the right tip on the gun. Instead of the detergent going out, the tank fills up with water. Whats the fix.? Thanks for any help . 'Robert in Md.
  9. R

    Decal removal

    I want to remove the side decals on my Farmall H without distroying the paint. The 2150 red paint is good but the decal white part has washed off. The company replaced the decals but I can,t get the old ones off. I tryed a heatgun without success. today. I imagine Lacquer thinner would...
  10. R

    Another question about a Little Genius plow

    Son just purchased a No. 8 Little Genius 2- 14,s plow for my H. Its the first plow we have found that is complete and in good condition with good tires. at the right price. Anyway this plow has unique disk coulters, 2 disks with one a an angle. The coulters say Lantz Kutter Kolter...
  11. R

    Super A front axle center pivot

    Talking about greasing the front of Super A.s , I have a 1953 Super A, the front axle center pivot does not have a grease zerk or any hole for one. It looks like there needs to be grease there. What does everyone else have. My MF 240 has a zerk at this pivot. Just curious...
  12. R

    Another BillyBob electrical question

    Son just brought home a Miller 115 volt, 30 amp Spot Welder. My shop has about 12 110volt ,15 and 20 amp circuits and several 220 volt 50 amp circuits. The neutrals and grounds are connected in the breaker box. My question is can I pull the 115 volts from one side of a 220 circuit and use...
  13. R

    Another Golfcart question?

    I've got a 1993 Easygo cart, 36 volt that works fine when its above 45 degrees but colder it goes to full speed when the peddle it pushed. This makes the cart dangerous to operate, with grandkids around. I want to correct the problem but don't know where to start. Can anyone help...
  14. R

    Dodge Pickup Automatic Transmission question

    I have a solid old 89 Dodge 3/4 ton pickup with a leaky transmission My mechanic says the front seal is leaking. There is oil everywhere around the transmission. My question is if I fill the transmission and the truck sits for 2 weeks the oil level has lost 2 quarts, is the oil level...
  15. R

    Bielers Mud sale, Pa. 2016

    I can not find the dates for the 2 day mud sale called Bielers mud sale held in Holtwood, Pa by the local fire dept. Thank you Robert in Md.
  16. R

    Installing a vfd on a drillpress

    Just purchased a vfd to reduce the speed of my Delta drill press. I have read the directions to hook it up but I don,t understand some of the directions .. Is all I have to do is hook the 220 single phase to the vfd and the 3 phase motor to the other side of the vfd. The hookup screws...
  17. R

    Paint colors for MF 240

    Went to the MF dealer today to get paint to repaint my 1983? MF 240. I painted the tractor about 10 years ago with MF paint. Red, medium gray for the frame and motor and silver _______ for the rims. as the dealer told me. Today at another dealer they had 2 reds and silver ______ for the...
  18. R

    Results of IH auction in Frederick,md , today

    There was a big IH 2 day auction in Frederick,md today and friday. Did anyone go and how did things sell? I wanted to go but with Knee Replacement just 2 weeks ago , I didnt think I could stand the ride or standing that long. Robert in Md.
  19. R

    Peanut Harvesting

    I planted some peanuts this year for the grandkids and myself. I would like to know when to dig them. The plants are starting to turn a little yellow and there are alot of filled peanuts on them. Do I need to wait until the plants die back and turn brown or can they be dug now.? I...
  20. R

    AC B runs poorly

    My AC B will start with the choke about 3/4 closed and will run only with that choke setting. Took carb off today and soaked it and blow out all the valves . Put back on , no better. Tractor doesn,t run good enough to use. What else can I do? Sounds like its not getting enough fuel...
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top