Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

TO 35 Hyd Lever Issue

Post new topic    
View previous topic :: View next topic  
Author Message

Joined: 28 Aug 2011
Posts: 26

Report to Moderator

PostPosted: Tue Sep 26, 2017 9:28 am    Post subject: TO 35 Hyd Lever Issue Reply to specific post Reply with quote

I have a 59 TO 35. All of a sudden the the hyd levers started working in reverse. The round knob lever will do nothing up or down, and the square knob lever is working in reverse. When you put handle down the 3ph raises, pull it up and 3ph lowers. Anyone had this issue.

Thanks Brian
Back to top
View user's profile
Tractor Guru

Joined: 12 Nov 2013
Posts: 10571

Report to Moderator

PostPosted: Wed Sep 27, 2017 7:34 am    Post subject: Re: TO 35 Hyd Lever Issue Reply to specific post Reply with quote

Can't say ever had them work backward...

Try putting the square (draft control) in the middle, between the dots.

Take the right cover off, look at the levers. Both should be in front of the roller on top of the valve lever.

Move the position control lever and watch the rods that move the valve lever. As you push the lever to the down position, the valve control roller should push to the rear. It won't move much, so watch carefully.

If that is not happening, sounds like something has come loose in the lever system up under the top cover. Especially if this happened on it's own without anything else being done. The roller should be lightly spring loaded against the back side of the levers. You can push it to the side and operate the lift manually, just be careful not to over travel it up.

That is a fairly complex system, a shop manual explains it better than I can here.
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Harry Ferguson All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters