Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Clutch problems


 
Post new topic    
View previous topic :: View next topic  
Author Message
Bailey's tree service
New User


Joined: 05 Dec 2017
Posts: 4


Report to Moderator

PostPosted: Tue Dec 05, 2017 1:59 pm    Post subject: Clutch problems Reply to specific post Reply with quote

I have a 674 international with the high and low 4 speed transmission, so I guess it's really a 8 speed! My question is that when I let my tractor sit overnight when I get on it I have to go from forward to reverse several times before the clutch will release and start pulling, but after it starts pulling it is fine. Any suggestions would be greatly appreciated
 
Back to top
View user's profile
JimB2
Tractor Expert


Joined: 04 Feb 2008
Posts: 2499


Report to Moderator

PostPosted: Tue Dec 05, 2017 6:30 pm    Post subject: Re: Clutch problems Reply to specific post Reply with quote

Hi, does you 674 have a T/A? Lever like the throttle lever but on left side of dash?

Is the clutch adjustment proper, about 3/4" free travel?

Does it do same thing if it is left in 1 Low, FWD or REV?

JimB
 
Back to top
View user's profile
Bailey's tree service
New User


Joined: 05 Dec 2017
Posts: 4


Report to Moderator

PostPosted: Tue Dec 05, 2017 8:50 pm    Post subject: Re: Clutch problems Reply to specific post Reply with quote

No sir their is no other lever other then the throttle lever, it is in low first in reverse, and yes I have about 7/8 free travel
 
Back to top
View user's profile
caterpillar guy
Tractor Expert


Joined: 24 Jun 2007
Posts: 2968


Report to Moderator

PostPosted: Wed Dec 06, 2017 2:22 pm    Post subject: Re: Clutch problems Reply to specific post Reply with quote

When was the last time the throw out bearing was greased ? There is a plate on the bottom of the clutch section there should be a grease fitting for the throw out bearing in there on the bottom of the bearing.
Look at Casih.com 574 clutch controls picture and number 7 is your grease fitting.
 
Back to top
View user's profile
Bailey's tree service
New User


Joined: 05 Dec 2017
Posts: 4


Report to Moderator

PostPosted: Wed Dec 06, 2017 5:40 pm    Post subject: Re: Clutch problems Reply to specific post Reply with quote

Found the grease fitting for the throw out bearing, actually went ahead and greased the whole tractor, it actually did seem to help a little but it's still not pulling till u go from "low range" forward and reverse, I counted today it took 22 times for it to actually engage and start pulling hard like it should, I had a five foot box blade behind it today and it pulled it fine all day after I rocked it back and fourth this morning
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Farmall & International Harvester (IHC) All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters