Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

TO30 rear axle inner seal?


 
Post new topic    
View previous topic :: View next topic  
Author Message
Kadbow
New User


Joined: 02 Feb 2018
Posts: 18


Report to Moderator

PostPosted: Fri Feb 02, 2018 9:27 am    Post subject: TO30 rear axle inner seal? Reply to specific post Reply with quote

A new to me TO30 that I am doing some work on. I have the rear axle pulled out and am ready to install the new inner seal. Which direction does it go? May be a dumb question but I just want to make sure I put it in right. It has a solid face and a seemed face. Thanks for the help.
 
Back to top
View user's profile
miner09
Tractor Expert


Joined: 02 Dec 2009
Posts: 2376


Report to Moderator

PostPosted: Fri Feb 02, 2018 1:11 pm    Post subject: Re: TO30 rear axle inner seal? Reply to specific post Reply with quote

The lip or open rubber goes to the oil side. You can see the spring inside if you pull
lip back a little. Put this toward the oil. Hope this helps. Just a way I always look
at it.
 
Back to top
View user's profile
Tom H.
Long Time User


Joined: 24 Feb 2008
Posts: 676


Report to Moderator

PostPosted: Fri Feb 02, 2018 2:59 pm    Post subject: Re: TO30 rear axle inner seal? Reply to specific post Reply with quote

As miner says lip or opening towards oil source. Learned the hard way with a rear main seal and spent the rest of the day respliting the tractor
to install a new one.
 
Back to top
View user's profile
Kadbow
New User


Joined: 02 Feb 2018
Posts: 18


Report to Moderator

PostPosted: Sat Feb 03, 2018 5:25 am    Post subject: Re: TO30 rear axle inner seal? Reply to specific post Reply with quote

Another question, the axle shaft is a little rough where I assume the seal sits/rubs on the shaft, will the seal seal if the shaft is not perfectly smooth?
 
Back to top
View user's profile
miner09
Tractor Expert


Joined: 02 Dec 2009
Posts: 2376


Report to Moderator

PostPosted: Sat Feb 03, 2018 7:46 am    Post subject: Re: TO30 rear axle inner seal? Reply to specific post Reply with quote

Take fine emory cloth and smooth it.
 
Back to top
View user's profile
Kadbow
New User


Joined: 02 Feb 2018
Posts: 18


Report to Moderator

PostPosted: Sat Feb 03, 2018 10:56 am    Post subject: Re: TO30 rear axle inner seal? Reply to specific post Reply with quote

Thanks for the great advice.
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Harry Ferguson All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters