Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

9n governor problem


 
Post new topic    
View previous topic :: View next topic  
Author Message
fscogin
New User


Joined: 19 Feb 2018
Posts: 1


Report to Moderator

PostPosted: Thu Feb 22, 2018 6:49 am    Post subject: 9n governor problem Reply to specific post Reply with quote

I recently had the engine rebuilt on my 9n. Starts and idles fine but the governor hunts when the rpms are increased. We thought there might be flat spots on the governor balls and when I took it down there were indeed small flat spots. we replaced the governor with a new one but this did not solve the problem, the governor still hunts. I've tried adjusting the governor and adjusting the carb but nothing seems to change the symptom. I'm getting a little desperate. I'm open to suggestions as to what else I can pursue.
BTW, without the governor linkage attached the carb will open and run full throttle by moving the throttle by hand.
Thanks,
Forrest
 
Back to top
View user's profile
R Geiger
Tractor Guru


Joined: 19 Apr 2009
Posts: 4568
Location: Banks, Oregon

Report to Moderator

PostPosted: Thu Feb 22, 2018 10:19 am    Post subject: Re: 9n governor problem Reply to specific post Reply with quote

I would rebuild the old one, parts are on this site.
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Ford 9N, 2N, 8N All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters