Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Hey Caterpillar guy

Post new topic    
View previous topic :: View next topic  
Author Message
Tractor Guru

Joined: 20 Jun 2007
Posts: 5020

Report to Moderator

PostPosted: Sun May 04, 2014 6:45 pm    Post subject: Hey Caterpillar guy Reply to specific post Reply with quote

Saw your post the other day asking for the specs on a 3306 crank. Sorry for the delayed response but I"m moving stuff from Dad"s shop to mine and things are in a bit of a mess so it took me a while to dig out one of my books. That said, here are the specs for you.

3.4992 +/- .0008

For the undergrinds simply subtract .010, .020., or .030 from that. They all have the same +/- of .0008


2.9992 +/- .0008

Same as above subtract the standard for the undergrind and keep the same +/- tolerance

If you need it, the clearance on the actual bearings are as follows.


New .0030 to .0066 with a max of .010


New .0030 to .0065 with a max of .010

Again sorry for the delay. Hope these help. I"ve got the book close now if you need anything else.
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Crawlers, Dozers, Loaders and Backhoes All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters