Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Oliver 90/99 water pump


 
Post new topic    
View previous topic :: View next topic  
Author Message
kwf
Regular


Joined: 25 Jul 2002
Posts: 190


Report to Moderator

PostPosted: Sun Dec 31, 2017 9:28 am    Post subject: Oliver 90/99 water pump Reply to specific post Reply with quote

Hey,
I need the parts to rebuild a water pump on an unstyled Oliver 99 4-cylinder tractor. I know there has been some topics on this before, didn't know if anyone had part numbers or places to get the parts to rebuild this water pump. Thanks.
 
Back to top
View user's profile
wilson ind
Tractor Expert


Joined: 16 Dec 2011
Posts: 3101
Location: linton indiana

Report to Moderator

PostPosted: Sun Dec 31, 2017 4:15 pm    Post subject: Re: Oliver 90/99 water pump Reply to specific post Reply with quote

Commercial pump Houston TX 712 864 5199 can rebuild about any h 2o pump
 
Back to top
View user's profile
Mike(NEOhio)
Tractor Guru


Joined: 12 May 2013
Posts: 3710
Location: Geauga County, Ohio

Report to Moderator

PostPosted: Sun Dec 31, 2017 5:10 pm    Post subject: Re: Oliver 90/99 water pump Reply to specific post Reply with quote

Kellog Automotive in Maricopa, Az.
 
Back to top
View user's profile
lstra
Regular


Joined: 03 Sep 2011
Posts: 62


Report to Moderator

PostPosted: Sun Dec 31, 2017 6:34 pm    Post subject: Re: Oliver 90/99 water pump Reply to specific post Reply with quote

Commercial Water Pump in Houston, Area Code is most likely 713.
 
Back to top
View user's profile
oliver90owner
Long Time User


Joined: 14 Feb 2011
Posts: 600


Report to Moderator

PostPosted: Mon Jan 01, 2018 1:40 am    Post subject: Re: Oliver 90/99 water pump Reply to specific post Reply with quote

Back over 30 years ago, I found the pump shaft a little rough due to, presumably, some leakage past the carbon seal and the bearings shot due to the housing being filled solid with hardened sludge. I replaced the seal with one made from a motor brush, replaced the oilite bearings (I drilled them out as they were too small - not the best way to do it!) and used an electrical cable sealing cover boot as well. This was obviously before the inter web and no spares were available on my side of the pond.

It leaked oil (as they always apparently did) but has not been a problem since. The tractor doesn?t get run much, mind. I am confident the repair will outlast me.
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Oliver, Cletrac, Coop and Cockshutt All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters