New Holland 50 Bale Thrower

[Jeff Wenner]

Had to replace some bearings on my Model 50 thrower. Can someone tell me the right way to tension the thrower belts back up and get them to track right? Thanks
 

[Our Farmer]

I don't know if it's the right way, but I can tell you how I did it on my 50.
If you look at the sides of the roller frames, you'll see two adjusting bolts on either side, top and bottom. In order for these to work, you need to find the carriage bolts that hold the roller frames from sliding in and out of the main frame, I think there are four for each frame. You'll see they ride in grooves that allow for adjustment. Loosen these and adjust the belt equally so it is has no play if you pull up on it. Then run the baler slowly, adjusting the each side so the thrower belt rides in the center of the rollers. Then shut 'er down and snug everything up good and tight.