Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Dexta Fixed. Super Major Injector Timing?

Post new topic    
View previous topic :: View next topic  
Author Message
Jack Mayers

Joined: 02 Jun 2006
Posts: 40
Location: Damascus, PA

Report to Moderator

PostPosted: Thu May 17, 2012 11:57 am    Post subject: Dexta Fixed. Super Major Injector Timing? Reply to specific post Reply with quote

Split the Dexta and adjusted the PTO screws. Working fine now. Decided to check the injector timing on my 1961 FSM. With the flywheel set at the 21 degrees before tdc the mark on the injector pump is still about 30 degrees off with the adjustment as far as it can go. It seems as if the flywheel is correct watching the rocker arms. Could it be possible the shaft comming from the governer is in the wrong place? Looking for suggestions. The tractor ran before I began to retime the pump but it had little power and was knocking. The manual suggested checking the pump timing. I don't know where to go from here.
Thank you,
845-594-1198 cell
PS. I have the pneumatic governor so the seting is 23 degrees, but that won't make much difference.

Last edited by Jack Mayers on Thu May 17, 2012 6:29 pm; edited 1 time in total
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Fordson All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters