Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

1962 D4c Transfer pump bleed hole leak?

Post new topic    
View previous topic :: View next topic  
Author Message

Joined: 19 Mar 2012
Posts: 35

Report to Moderator

PostPosted: Sun Jun 10, 2012 4:11 pm    Post subject: 1962 D4c Transfer pump bleed hole leak? Reply to specific post Reply with quote

I had the cat dealer install new seals and a bushing in the transfer pump. I have about one drop every ten seconds out of the bleed orfice in the pump. Seems to me should be no leaking? Should I bring it back to them? Any help is appriciated. Thank you!!!!!
Back to top
View user's profile
Tractor Guru

Joined: 20 Jun 2007
Posts: 5026

Report to Moderator

PostPosted: Sun Jun 10, 2012 5:47 pm    Post subject: Re: 1962 D4c Transfer pump bleed hole leak? Reply to specific post Reply with quote

Your right, there should be no leakage out of the weep hole. Of course if the shaft was scored or had a seal groove, etc and they didn't change that as part of the rebuild then your lucky that a drop is all your getting. Nowdays your usually better off to go the aftermarket route and just get a new pump rather than having an old one rebuilt. One note on the aftermarket pumps. Unless the "CAT classic" pumps have changed significantly in the past few years stay away from them. The first, and only one of them I bought for a customer had to be swapped out three times and every one of them leaked worse than the origional pump. Wound up taking the third pump and buying a rebuild kit for it to get bearings tight enough to keep the shaft centered enough for the seals to work.

Good luck.
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Crawlers, Dozers, Loaders and Backhoes All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters