Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

adjusting govenor


 
Post new topic    
View previous topic :: View next topic  
Author Message
locknload74
New User


Joined: 13 Jul 2012
Posts: 4


Report to Moderator

PostPosted: Sun Jul 22, 2012 2:59 pm    Post subject: adjusting govenor Reply to specific post Reply with quote

how do u adjusted a govenor on a 1956 international cub
 
Back to top
View user's profile
jbp
Long Time User


Joined: 05 Mar 2009
Posts: 973


Report to Moderator

PostPosted: Sat Jul 28, 2012 9:15 am    Post subject: Re: adjusting govenor Reply to specific post Reply with quote

I assume you are talking about the throttle linkage between the governor and the carburetor. With the engine off, remove the pin from the clevis that attaches the carb linkage to the governor lever. With the hand throttle wide open and the carb butterfly wide open the length of the linkage should be 1 turn too long to replace the pin back in the clevis without moving the governor lever. If everything else is in order that should give good governor function. Joe
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Restoration and Repair Tips All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters