|
This is the modern view of the Yesterday's Tractors Forums. Just login with your YT Userid and password to post. If you have trouble logging in, contact us by email to support at ytmag.com, or through the Reader Form, and we will get you going right away.
| View previous topic :: View next topic |
| Author |
Message |
Craig H
New User
Joined: 12 Aug 2012
Posts: 1
Report to Moderator
|
 Posted: Sun Aug 12, 2012 4:43 pm Post subject: Allis Chalmers WD hand cluch |
  |
|
Is there a way to replace the brass shifter for the hand clutch without splitting the tractor? Mine is cracked and I can take the top bolt out but having trouble getting at the lower one. Thanks for any suggestions.
|
|
| Back to top |
|
 |
JMS/.MN
Tractor Guru
Joined: 05 Mar 2009
Posts: 5965
Report to Moderator
|
| Posted: Mon Aug 13, 2012 9:27 am Post subject: Re: Allis Chalmers WD hand cluch |
|
|
I don"t think so cuz you need to rotate the lower half of the bearing, and the yoke won"t release it, unless you could loosen the yoke from the pivot shaft. Only one I did, I had the engine out and just loosened the next two castings to the rear. Needed gaskets anyway. Other way is to loosen frame from axle, and shove apart a bit using guide pins in the frame bolt holes. I&T AC 11 has some pix of that.
|
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
|
|
Discount Prices for Parts! You can help support this extensive website by purchasing your tractor parts, manuals and merchandise from our [ Antique Tractor Store ] or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
|
YT Home
| Tractor Manuals
| Tractor Parts
| Forum Home
Copyright © 1997-2013 Yesterday's Tractor Co. - A Washington State Corporation
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
