|
This is the modern view of the Yesterday's Tractors Forums. Just login with your YT Userid and password to post. If you have trouble logging in, contact us by email to support at ytmag.com, or through the Reader Form, and we will get you going right away.
| View previous topic :: View next topic |
| Author |
Message |
PackardV8
Regular
Joined: 23 Jan 2011
Posts: 146
Report to Moderator
|
 Posted: Sat Aug 18, 2012 6:05 pm Post subject: Cracked 80 mm Standard block. |
  |
|
This message is a reply to an archived post by Bill Brox on March 01, 2012 at 13:30:58.
The original subject was "Re: Cracked 80 mm Standard block.".
I have a TE20 wit h Standard engine and block is cracked at the bottom (near bottom of liners) between #3 and #4 cylinders. I"m worried about welding because of the liner sealing/gaskets near the bottom.
Any suggestions?????
|
|
| Back to top |
|
 |
j w in tennessee
Guest
Report to Moderator
|
| Posted: Sat Aug 18, 2012 7:00 pm Post subject: Re: Cracked 80 mm Standard block. |
|
|
go just above the webb that is cracked between 3-4 aND drill a 1/2 hole through the block from each side,put a 1/2 bolt through it and seal with silcone or some type of sealer and draw it tight.it should hold for a long time
|
|
| Back to top |
|
|
David Shea
Guest
Report to Moderator
|
| Posted: Thu Aug 23, 2012 6:01 pm Post subject: Re: Cracked 80 mm Standard block. |
|
|
I have a TE 20 block for sale.
802-782-2409
|
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
|
|
Discount Prices for Parts! You can help support this extensive website by purchasing your tractor parts, manuals and merchandise from our [ Antique Tractor Store ] or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
|
YT Home
| Tractor Manuals
| Tractor Parts
| Forum Home
Copyright © 1997-2013 Yesterday's Tractor Co. - A Washington State Corporation
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
