part for allis chalmers D15 dozer

[Fran Gordon]

Hi, Have a H3 D15 gas powered allis chalmers dozer. It has a shuttle clutch.

What I am needing are clutch shims.
Sizes I need are .005 and.010. I need 6 of each of these if possible. If there is anyone out there that has any idea as to where I might find these I would really appreciate it.

Thanks So Much
 

[Bob Bancroft]

At the AC dealer where I used to work there was a drawer full of shims. Some were the long and short ones for the power director clutches. I assume the shuttle clutches used the same shims.
No AC dealers you can contact?
 

[Fran Gordon]

Bob, Thanks for the reply Have been calling for three days and still no luck.

Thanks Fran
 

[steve(ill)]

Is that something you can cut out yourself " We use to buy .005 and .010 stock and cut with heavy sizors. Used gasket punches to puch out the holes. Little tough on the punches, but does work.