Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Allis B Zenith 9705 Carburetor


 
Post new topic    
View previous topic :: View next topic  
Author Message
carbonfibers
Regular


Joined: 18 Feb 2008
Posts: 140


Report to Moderator

PostPosted: Fri Sep 21, 2012 4:16 pm    Post subject: Allis B Zenith 9705 Carburetor Reply to specific post Reply with quote

What is the little brass (orifice or plug? ) in the throat of the carburetor right where the throttle plate seats closed ? It is right above the idle mixture screw. Is this a common part in a complete carburetor rebuild kit ? I had to punch mine out because I could not get it to unscrew. It now appears that it is pressed in and has something to do with the idle fuel? I did not see a part number in the manual but it is shown on the diagram.

Any help wouold be appriciated.

Thanks
Wayne
 
Back to top
View user's profile
chalmersbob(Pa)
Regular


Joined: 04 Jun 2009
Posts: 435


Report to Moderator

PostPosted: Fri Sep 21, 2012 7:33 pm    Post subject: Re: Allis B Zenith 9705 Carburetor Reply to specific post Reply with quote

That is the idle jet, and it should screw out. I usually remove the adjusting screw and run a fine wire through the jet, then blow it out. I have never seen one in a rebuild kit. I might have an extra one around, I'll check. Bob
 
Back to top
View user's profile
carbonfibers
Regular


Joined: 18 Feb 2008
Posts: 140


Report to Moderator

PostPosted: Sat Sep 22, 2012 7:21 am    Post subject: Re: Allis B Zenith 9705 Carburetor Reply to specific post Reply with quote

Thanks Bob, if you have one that would make my day. I will purchase it from you.


Wayne
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Allis Chalmers All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters