Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Identify turning plow


 
Post new topic    
View previous topic :: View next topic  
Author Message
1twodoor
Guest






Report to Moderator

PostPosted: Wed Sep 26, 2012 5:31 pm    Post subject: Identify turning plow Reply to specific post Reply with quote

I need help identifying turning plow. It is a Farmall, four disk with a tail wheel and one point hitch. Trying to get so I can order a manual and get parts numbers for bearings and seals.
 
Back to top
DeltaRed
Tractor Guru


Joined: 25 Feb 2010
Posts: 9652
Location: Delta,colorado

Report to Moderator

PostPosted: Wed Sep 26, 2012 6:07 pm    Post subject: Re: Identify turning plow Reply to specific post Reply with quote

A one point hitch identifies it as a Cub or 140 tool.4 disks is a little big of a plow for a Cub/140.Sounds more like a small disk or a cultivator/ridger of sorts.Post a pic or two so we can see exactly we are talking about.We need to see it!
 
Back to top
View user's profile
1twodoor
Guest






Report to Moderator

PostPosted: Thu Sep 27, 2012 5:21 pm    Post subject: Re: Identify turning plow Reply to specific post Reply with quote

Thanks for the reply, I will try to get pictures. It is used behind a 140. Trying to replace bearings and seal in tail wheel, so much wear that having a hard time getting numbers off old parts.
 
Back to top
Tx Jim
Tractor Guru


Joined: 14 Feb 1999
Posts: 17582
Location: Coyote Flats,Tx

Report to Moderator

PostPosted: Fri Sep 28, 2012 5:16 am    Post subject: Re: Identify turning plow Reply to specific post Reply with quote


If a 140 can pull it then it must be a disk tiller not a breaking plow.
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Implement Alley All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters