Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

oil trap


 
Post new topic    
View previous topic :: View next topic  
Author Message
Hilltopper
Long Time User


Joined: 22 Feb 2000
Posts: 683


Report to Moderator

PostPosted: Thu Sep 27, 2012 5:33 pm    Post subject: oil trap Reply to specific post Reply with quote

I have been working on a 64 3020 gas. It is supposed to have an oil trap in the air stack at top of the airfilter unit. It shows sign that it has been cut out. I was wondering if they were removed by Deere. The later models after sn 85000 do no have this. My problem is if the engine stalls it throws oil from the air filter inlet back on the hood makes a mess on the new paint job.
 
Back to top
View user's profile
Tx Jim
Tractor Guru


Joined: 14 Feb 1999
Posts: 17594
Location: Coyote Flats,Tx

Report to Moderator

PostPosted: Fri Sep 28, 2012 3:49 am    Post subject: Re: oil trap Reply to specific post Reply with quote


I don't remember anything about an oil trap in the air cleaner from when I was a service manager.
 
Back to top
View user's profile
Hilltopper
Long Time User


Joined: 22 Feb 2000
Posts: 683


Report to Moderator

PostPosted: Fri Sep 28, 2012 12:42 pm    Post subject: Re: oil trap Reply to specific post Reply with quote

It is pictured in the service and operators manual. I guess it was to catch oil going up the air cleaner stack when the engine rolled backward. It may have become a choke point and caused high fuel consumption if not serviced which required removal of the hood. Thanks
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> John Deere All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters