Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

John Deere 310 backhoe help needed


 
Post new topic    
View previous topic :: View next topic  
Author Message
acyoung
New User


Joined: 04 Oct 2012
Posts: 2


Report to Moderator

PostPosted: Thu Oct 04, 2012 2:59 pm    Post subject: John Deere 310 backhoe help needed Reply to specific post Reply with quote

I ran my John Deere 310 C low on fuel (the fuel gauge was not working when I purchased). I put on a new filter, bled the line and then loosend what I thought was a bleed screw on the injection pump. With that screw loose (and fuel leaking), the tractor starts and runs good, but when I tighten the screw, the tracotr looses power and dies. What am i doing wrong? Thanks in advance!
 
Back to top
View user's profile
russ in ct
Guest






Report to Moderator

PostPosted: Thu Oct 04, 2012 3:32 pm    Post subject: Re: John Deere 310 backhoe help needed Reply to specific post Reply with quote

check for a plugged return line.
 
Back to top
Outbackrider
Guest






Report to Moderator

PostPosted: Fri Oct 05, 2012 7:43 am    Post subject: Re: John Deere 310 backhoe help needed Reply to specific post Reply with quote

Did you bleed the air from the filter, should be a Bleed screw on top of fuel filter housing. Crack it open and pump the manual pump until fuel comes out. Make sure priming pump handle is pushed back towards the engine when your done priming.
 
Back to top
acyoung
New User


Joined: 04 Oct 2012
Posts: 2


Report to Moderator

PostPosted: Sat Oct 06, 2012 10:00 am    Post subject: Re: John Deere 310 backhoe help needed Reply to specific post Reply with quote

It was a plugged return line. Thanks for the help!
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Crawlers, Dozers, Loaders and Backhoes All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters