Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

rebuilt 9n


 
Post new topic    
View previous topic :: View next topic  
Author Message
93699mopar
New User


Joined: 04 Oct 2012
Posts: 1


Report to Moderator

PostPosted: Thu Oct 04, 2012 6:26 pm    Post subject: rebuilt 9n Reply to specific post Reply with quote

finally got my 9n put back together after three months of working on it on my ten days off here and there. rubuilding the engine and replacing bearings in both transmissions turned into rebuilding the engine both transmissions and working over the hydrolics. works like a well oiled machine. had a minor set back with shearing the oilpump drive gear, but got it all straightened out and it holds over 50 psi cold and about 20 warm at idle. found the gasket on the lift cylinder blown out was the cause of my weak hydrolics. lifts and holds as it should now. thanks to all of you for educating me about these neat little machines before i tore it down.
 
Back to top
View user's profile
HCooke
Tractor Guru


Joined: 29 Sep 2006
Posts: 4113
Location: Missouri

Report to Moderator

PostPosted: Fri Oct 05, 2012 4:32 am    Post subject: Re: rebuilt 9n Reply to specific post Reply with quote

Glad to hear it. And, they are neat little machines.
 
Back to top
View user's profile
Ken Biggs
Guest






Report to Moderator

PostPosted: Sat Oct 06, 2012 11:28 am    Post subject: Re: rebuilt 9n Reply to specific post Reply with quote

Re: gasket on the lift cylinder , Could you just give mne a hint or reference in the repair manual, Yeah I know !.
Thanks.
KB
 
Back to top
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Ford 9N, 2N, 8N All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters