Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Davis Loaderhelp


 
Post new topic    
View previous topic :: View next topic  
Author Message
Longmeadow farm
Regular


Joined: 11 Nov 2010
Posts: 281


Report to Moderator

PostPosted: Sat Oct 06, 2012 9:44 am    Post subject: Davis Loaderhelp Reply to specific post Reply with quote

My brother-in-law wants to mount a recently purchased model 101-A Davis loader, formerly mounted on a Ford NAA ... on a gas powered Massey Ferguson 135. He is missing the front mounting hardware/bracket that goes under the front of the 135 engine and probably mounts to the side of the engine block. Any ideas of where I may be able to find the part or at least an appropriate parts manual ..probably could make one... thanks
 
Back to top
View user's profile
Inno
Tractor Expert


Joined: 11 Nov 2009
Posts: 2407
Location: NW Ontario Canada, Near Beautiful Rainy Lake

Report to Moderator

PostPosted: Sat Oct 06, 2012 2:43 pm    Post subject: Re: Davis Loaderhelp Reply to specific post Reply with quote

I just took a 99 Davis loader off my TO-35 although the mount was pretty rusted out in some spots.
It bolted on underneath the front end.........not sure if would be even similar on a 135 but I could take some pictures of the mount if you think it might help.
 
Back to top
View user's profile
Longmeadow farm
Regular


Joined: 11 Nov 2010
Posts: 281


Report to Moderator

PostPosted: Sun Oct 07, 2012 3:55 am    Post subject: Re: Davis Loaderhelp Reply to specific post Reply with quote

Thanks for the offer, I'm sure it would be a great help to obtain a picture...you can e-mail the picture when you get a chance. I suspect the mount, while not identical, would be somewhat similar and give us at least a starting point. I have posted requests and "shopped" around.. but no luck so far. Where are you located...?? perhaps you ship us the rusted part... we'll pay of course. We are located in the Albany area of New York State.
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Massey Harris & Massey Ferguson All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters