Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

hydro. fluid (again)


 
Post new topic    
View previous topic :: View next topic  
Author Message
howdy1960
Tractor Expert


Joined: 15 Jul 2012
Posts: 1541


Report to Moderator

PostPosted: Sat Oct 06, 2012 1:08 pm    Post subject: hydro. fluid (again) Reply to specific post Reply with quote

Have a Dearborn 19-61 FEL that I replaced the fluid in. I used TSC universal tranny/hydro fluid. It seemed a little thin compared to what I removed. I replaced as it had water in it. Now fluid bubbles up and loader is erratic in action. It lifts then drops while lever is in lift position. Dump action is same way. Also makes a noise that sounds like a PS pump low on fluid. Is it possable/permisable to add thicker fluid (thinking 80-90 gear oil) to what what I have? How about 10-30/40 motor oil~squiggly eyes~ ? Any suggestions? Thanks for any help you offer.
 
Back to top
View user's profile
souNdguy
Tractor Guru


Joined: 20 Aug 2002
Posts: 53039


Report to Moderator

PostPosted: Sat Oct 06, 2012 1:23 pm    Post subject: Re: hydro. fluid (again) Reply to specific post Reply with quote

sounds like cavitation, and you have LOTS of air in the system..

thicker fluid is not the answer.. and the thinner utf is not the problem.

cycle it good.. refill.. make sure any fitler present is new.. once all cy;s are purged and sump is correct and filters serviced.. should be fine.
 
Back to top
View user's profile
old
Tractor Guru


Joined: 12 Mar 2000
Posts: 56428
Location: Lake of the Ozarks area of MO

Report to Moderator

PostPosted: Sat Oct 06, 2012 1:36 pm    Post subject: Re: hydro. fluid (again) Reply to specific post Reply with quote

I agree with sound you need to open and close the cylinders a number of times to bleed the air out of the system
 
Back to top
View user's profile
howdy1960
Tractor Expert


Joined: 15 Jul 2012
Posts: 1541


Report to Moderator

PostPosted: Sat Oct 06, 2012 1:46 pm    Post subject: Re: hydro. fluid (again) Reply to specific post Reply with quote

Thanks again guys Smile
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Ford 9N, 2N, 8N All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters