Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

574 trim


 
Post new topic    
View previous topic :: View next topic  
Author Message
iH to the bone
New User


Joined: 10 Oct 2012
Posts: 2


Report to Moderator

PostPosted: Wed Oct 10, 2012 2:27 pm    Post subject: 574 trim Reply to specific post Reply with quote

Why do some 574 hoods have decals and some have the shiny metal strips? Have a pair of 73's ,one each way.
 
Back to top
View user's profile
mkirsch
Tractor Guru


Joined: 08 Oct 2007
Posts: 9725


Report to Moderator

PostPosted: Thu Oct 11, 2012 5:21 am    Post subject: Re: 574 trim Reply to specific post Reply with quote

Early 70's is when IH went from die-cast emblems to decals on their tractors. On their big tractors they waited for the new series to make the switch. 56 series had emblems up to 1971. 66 series had decals starting in late '71.

The 574 was made from 1970-1978 so they spanned the 56-66-86 series. IH probably put emblems on the early ones to match the 56 series, and switched to decals when the emblem supply ran out.

Betcha the one with emblems is an early '73 and the stickers is a mid to late '73 with a higher serial number. If not, then ya got me...
 
Back to top
View user's profile
iH to the bone
New User


Joined: 10 Oct 2012
Posts: 2


Report to Moderator

PostPosted: Thu Oct 11, 2012 12:50 pm    Post subject: Re: 574 trim Reply to specific post Reply with quote

That makes way too much sense. One Ser # is mid year and the other is toward the end of the run for "73. As many of them (574 & 674 ) are here in Middle Tn I had never seen the metal strip till this one. The number part of the badge is applied with an adhesive backing so it could have any number stuck on the end of the strip. Thanks.
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Farmall & International Harvester (IHC) All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters