Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

M5 Muffler?


 
Post new topic    
View previous topic :: View next topic  
Author Message
Alan K
Tractor Guru


Joined: 09 May 1999
Posts: 3575


Report to Moderator

PostPosted: Fri Oct 12, 2012 9:54 am    Post subject: M5 Muffler? Reply to specific post Reply with quote

Has anyone bought a muffler for the M5-M670s from agco? Ive bought the stanley ones but....they dont "muffle" anything much anymore. The stanley one my dad bought for the ZA years ago I have to wear ear plugs when I use it.
 
Back to top
View user's profile
Heath72
Regular


Joined: 12 Dec 2009
Posts: 319


Report to Moderator

PostPosted: Fri Oct 12, 2012 4:16 pm    Post subject: Re: M5 Muffler? Reply to specific post Reply with quote

Alan, I checked into a muffler from Agco a few years ago, and it was the cheap Stanley at three times the price my local farm supply store charges. Needless to say I turned it down.

I checked into other mufflers, and finally decided to buy a 4020 muffler from John Deere. This required getting a short piece of heavy-wall pipe for an adapter. It was machined on the inside on one end to fit over the MM manifold, then machined on the outside on the top end for the JD muffler. It only cost a few bucks at my local mchine shop, and allowed me to use a much better quality muffler. This muffler is MUCH quieter than the old Stanley. I think the muffler from Deere was only $60.
 
Back to top
View user's profile
Alan K
Tractor Guru


Joined: 09 May 1999
Posts: 3575


Report to Moderator

PostPosted: Fri Oct 12, 2012 5:36 pm    Post subject: Re: M5 Muffler? Reply to specific post Reply with quote

I wondered if that is what agco did. The stanley mufflers used to be better. I do happen to have one for a 4020 I might have to try. Thank you.
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Minneapolis Moline All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters