Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

2000 drawbar


 
Post new topic    
View previous topic :: View next topic  
Author Message
L.C. Gray
Regular


Joined: 05 Mar 2009
Posts: 76


Report to Moderator

PostPosted: Sun Oct 21, 2012 5:44 am    Post subject: 2000 drawbar Reply to specific post Reply with quote

I have a 1963 Ford 2000 that's missing the drawbar. I have an old drawbar laying around that looks like it would be a good fit other than I think it's too long. I'm considering cutting it shorter and redrilling the pin hole to make it match the original drawbar's length.

What is the distance from the attaching pin hole to the hitch pin hole on the factory drawbar?
 
Back to top
View user's profile
mhb@ufe
Long Time User


Joined: 05 Mar 2009
Posts: 1374
Location: Jefferson Maine

Report to Moderator

PostPosted: Sun Oct 21, 2012 2:22 pm    Post subject: Re: 2000 drawbar Reply to specific post Reply with quote

I don't have that measurement but if I remember correctly the pin hole in the end of the draw bar should be 14 inches back from the end of the PTO shaft.


Mark
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Ford All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters