Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

centaur kv magneto


 
Post new topic    
View previous topic :: View next topic  
Author Message
lee thomas
Regular


Joined: 08 Oct 2003
Posts: 166


Report to Moderator

PostPosted: Mon Nov 05, 2012 6:54 am    Post subject: centaur kv magneto Reply to specific post Reply with quote

I am in need of a gear housing for a wico type a magneto 633-9431 is the only numbers on it the gear housing is part #x5292 or a complete mag for a 1936 centaur kv does any one have any idea where i might find find one thanks
 
Back to top
View user's profile
El Toro
Tractor Guru


Joined: 04 Jun 2004
Posts: 22433


Report to Moderator

PostPosted: Mon Nov 05, 2012 10:54 am    Post subject: Re: centaur kv magneto Reply to specific post Reply with quote

Give Standard Magneto a call. They may have the parts or a complete replacement mag. Hal
1-800-624-6386
 
Back to top
View user's profile
lee thomas
Regular


Joined: 08 Oct 2003
Posts: 166


Report to Moderator

PostPosted: Mon Nov 05, 2012 12:38 pm    Post subject: Re: centaur kv magneto Reply to specific post Reply with quote

Thanks I have already talked to rich at standard mag they are trying to find a used piece to fix mine with .I guess new is not avaible
 
Back to top
View user's profile
El Toro
Tractor Guru


Joined: 04 Jun 2004
Posts: 22433


Report to Moderator

PostPosted: Tue Nov 06, 2012 6:26 am    Post subject: Re: centaur kv magneto Reply to specific post Reply with quote

They also made a distributor for that tractor. The part number is IGW-4121A made by Autolite. You can convert that mag to a distributor if the points will open and close & by using an auto type coil.
You would need to run battery voltage to a switch
and from the switch to the coil and another wire to your points. You still need the condenser too and disconnect the mag's coil wire to the points. Hal
PS: That distributor is probably scarce.
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Lesser Known Classics All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters