|
This is the modern view of the Yesterday's Tractors Forums. Just login with your YT Userid and password to post. If you have trouble logging in, contact us by email to support at ytmag.com, or through the Reader Form, and we will get you going right away.
| View previous topic :: View next topic |
| Author |
Message |
Jeff=-oh
New User
Joined: 09 Sep 2012
Posts: 3
Report to Moderator
|
 Posted: Fri Nov 09, 2012 7:03 pm Post subject: DON TX |
  |
|
You asked how the DIst cap from YT here fit.
YTmag sells the A&I aftermarket parts and I got the one labeled for the orginal dist. There is also one labled for their aftermarket dist. also.
It came in and fit just fine. Even the "Made in England" markings were the same.
Only complaint, if you want to call it one, is the center coit terminal on the inside dangles from a spring and I felt I had to be careful not to break it off when assembling.
However, it seems to work just fine.
Jeff
|
|
| Back to top |
|
 |
DON TX
Tractor Expert
Joined: 09 Aug 2001
Posts: 2251
Location: Midlothian, Tx
Report to Moderator
|
| Posted: Fri Nov 09, 2012 8:28 pm Post subject: Re: DON TX |
|
|
Thanks. I have had caps for other vehicles with that same setup. Can't remember which ones. Thanks for the review. Just for the archives, it was for a TE 20 Lucas distributor, right?
I just flushed the engine of vinegar and filled with antifreeze and water. I ran it and got it warmed to circulation. It puked a few times till it leveled itself and I put the cap on and ran it to see if it would puke again. It didn't so I'm ready to move on to the next stage. I'm spending at least a half of Saturday to timing and carb adjustments to see what kind of power it has.
DON TX
|
|
| Back to top |
|
|
Jeff-oh
Tractor Guru
Joined: 04 Sep 2002
Posts: 5147
Location: SW Ohio
Report to Moderator
|
| Posted: Sat Nov 10, 2012 5:05 am Post subject: Re: DON TX |
|
|
Yes, This cap is for the TE-20 and TEA-20"s with the Lucas Dist.
|
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
|
|
Discount Prices for Parts! You can help support this extensive website by purchasing your tractor parts, manuals and merchandise from our [ Antique Tractor Store ] or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
|
YT Home
| Tractor Manuals
| Tractor Parts
| Forum Home
Copyright © 1997-2013 Yesterday's Tractor Co. - A Washington State Corporation
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
