|
This is the modern view of the Yesterday's Tractors Forums. Just login with your YT Userid and password to post. If you have trouble logging in, contact us by email to support at ytmag.com, or through the Reader Form, and we will get you going right away.
| View previous topic :: View next topic |
| Author |
Message |
Icuby
Regular
Joined: 05 Mar 2009
Posts: 174
Report to Moderator
|
 Posted: Fri Nov 09, 2012 7:26 pm Post subject: 886 360cid inj.pump |
  |
|
Looking for break down of this American Bosch pump. It is leaking fuel around the head of the pump and was wondering if this pump has to be taken off and sent to a pump repair shop. thanks
|
|
| Back to top |
|
 |
pete 23
Tractor Expert
Joined: 10 Sep 2009
Posts: 2936
Report to Moderator
|
| Posted: Sat Nov 10, 2012 9:46 am Post subject: Re: 886 360cid inj.pump |
|
|
Leaking around the head of pump usually requires the housing be replaced as they get a groove worn in them and then a new o-ring will not seal. You would need pump completely gone through.
To remove pump, remove the side cover, four screws, turn engine until mark comes around on gear, then turn a little more until timing mark lines on hub up with pointer which is under front pump cover. That will be about 18 degrees before tdc on front pulley.
|
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
|
|
Discount Prices for Parts! You can help support this extensive website by purchasing your tractor parts, manuals and merchandise from our [ Antique Tractor Store ] or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
|
YT Home
| Tractor Manuals
| Tractor Parts
| Forum Home
Copyright © 1997-2013 Yesterday's Tractor Co. - A Washington State Corporation
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
