Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

37A unstyled ??


 
Post new topic    
View previous topic :: View next topic  
Author Message
Bob in Oakboro
Regular


Joined: 01 Nov 2007
Posts: 199


Report to Moderator

PostPosted: Fri Nov 09, 2012 8:09 pm    Post subject: 37A unstyled ?? Reply to specific post Reply with quote

I have been looking for an unstyled A or B for a while. I found one that has solid metal type rims on the rear. (not spokes) Could these be original? or did they all come with spokes or slats that were usually cut off to put new rims for rubber tires.
 
Back to top
View user's profile
A GURU
Long Time User


Joined: 01 Jan 2010
Posts: 594
Location: Brighton Colorado

Report to Moderator

PostPosted: Sat Nov 10, 2012 4:19 am    Post subject: Re: 37A unstyled ?? Reply to specific post Reply with quote

They could be original if they are cast wheels with demountable rims. Cast wheels became available in the 36 model year and continued from there.
Original cast wheels were introduced in June 36 and were used up to 460000 (ten spline). These wheels used a drawn in tapered sleeve. Above 460000 (twelve spline) had the splined portion of the hub as an integral part of the cast disc and used a locking collar to tighten them down.
Stamped steel wheels (38") were not available during this time, but hubs were made available later with the corresponding spline pattern to accept these wheels.
Hope this helps.
 
Back to top
View user's profile
RandyB(MI)
Tractor Guru


Joined: 06 Jan 2006
Posts: 3894
Location: Mt. Pleasant , MI.

Report to Moderator

PostPosted: Sat Nov 10, 2012 3:36 pm    Post subject: Re: 37A unstyled ?? Reply to specific post Reply with quote

If it is the "A" listed in photo classifieds , I don't believe those rears are original as owner stated.
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> John Deere All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters