Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

New engine


 
Post new topic    
View previous topic :: View next topic  
Author Message
dgerth
Regular


Joined: 25 Aug 2008
Posts: 83
Location: central WA pnw

Report to Moderator

PostPosted: Sun Nov 25, 2012 6:55 am    Post subject: New engine Reply to specific post Reply with quote

Gentlemen,
I have acquired a TEA/TO-20, not too sure which,
with a Z-129 motor which has a nasty oil/water mix in the pan. My ?, What is the largest motor that can be bolted on, as in no mods or adapter etc used ?
Just asking tho. May only be a head gasket.
tks,
dg
 
Back to top
View user's profile
DanP
Regular


Joined: 11 Dec 2011
Posts: 89


Report to Moderator

PostPosted: Sun Nov 25, 2012 7:24 am    Post subject: Re: New engine Reply to specific post Reply with quote

I have a TO-20 that I plan, with a little motivation, to dissassemble this spring/summer. Never had engine running, but had coolant in radiator and oil in pan, and turns over, so think block is good. If you are close to Central Ma, we can work something out.
 
Back to top
View user's profile
Jerry/MT
Tractor Guru


Joined: 22 Jul 2003
Posts: 10104
Location: Western Montana

Report to Moderator

PostPosted: Sun Nov 25, 2012 1:14 pm    Post subject: Re: New engine Reply to specific post Reply with quote

if it has a Z129 it"s most likely a TO-30.
 
Back to top
View user's profile
John(UK)
Long Time User


Joined: 24 Oct 2007
Posts: 1176


Report to Moderator

PostPosted: Mon Nov 26, 2012 4:14 am    Post subject: Re: New engine Reply to specific post Reply with quote

It will almost certainly be a TO30 unless someone has changed the Engine. The water in the oil, it may be the Head gasket or a cracked Head or the seals on the bottom of the Sleeves. I have just been reading about someone who fitted a 6 cylinder Perkins Diesel into one, but it was a lot of work..nothing is impossible with these tractors...John(UK)....fergusontractors@hotmail.com
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Harry Ferguson All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters