Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Caterpillar D6 or D8


 
Post new topic    
View previous topic :: View next topic  
Author Message
Ron Jedlicka
New User


Joined: 27 Nov 2012
Posts: 1


Report to Moderator

PostPosted: Tue Nov 27, 2012 12:26 pm    Post subject: Caterpillar D6 or D8 Reply to specific post Reply with quote

I acquired a 100 KW 250 Volt generator that was opearated by a TD 25 bulldozer. The old guy operated his coal mine operation with it. The TD25 would back into his shed and connect the generator up to TD 25 by using V belts. He would drive the tractor forward putting tension on the belts there by operating the generator through his PTO belt pulley. The TD25 is long gone. But I have a old D6 and a older D8.I am looking to duplicate this set up. Does any one have an idea where I can pick up a PTO for either of these tractors? I have seen D4 belt pulleys forsale maybe I could adapt one.
 
Back to top
View user's profile
jm.
Tractor Expert


Joined: 11 Apr 2010
Posts: 2478
Location: Dover Tenn.

Report to Moderator

PostPosted: Tue Nov 27, 2012 5:14 pm    Post subject: Re: Caterpillar D6 or D8 Reply to specific post Reply with quote

I think you had better be thinking the D-8 ..Might load the d6 engine .Do you already have the dozer? If not just find a power unit. You can go over to www.acmoc.org web site. They have a bulletin board where you can post your want to buy. Might have luck there.
 
Back to top
View user's profile
Joel59
Regular


Joined: 07 Apr 2006
Posts: 48


Report to Moderator

PostPosted: Wed Nov 28, 2012 6:18 am    Post subject: Re: Caterpillar D6 or D8 Reply to specific post Reply with quote

I know where there are 2 TD25s for sale with good engines and worn undercarriages if you want to duplicate the original setup.
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Crawlers, Dozers, Loaders and Backhoes All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters