|
This is the modern view of the Yesterday's Tractors Forums. Just login with your YT Userid and password to post. If you have trouble logging in, contact us by email to support at ytmag.com, or through the Reader Form, and we will get you going right away.
| View previous topic :: View next topic |
| Author |
Message |
Pete (NY)
Guest
Report to Moderator
|
 Posted: Wed Dec 12, 2012 6:47 am Post subject: Help migging alum. |
  |
|
I can't seem to get the welder dialed in and any tips would be appreciated. I used a ss wire brush to clean the area. I am using the recommended settings on the welder for amperage and wirespeed. The flow is set to 30. I am using a push technique with the tip around 3/4" away and a small angle opposite of travel. Using a Hobart with spool gun. I used to get smooth flowing welds that looked good. The wire is a few years old. Could the wire be oxzidized? Not getting the spray transfer hiss, kind of popping sound. I can't dial in to the problem, technique, gas coverage, settings? Thanks for any input.
|
|
| Back to top |
|
 |
Stick welding
Guest
Report to Moderator
|
| Posted: Thu Dec 13, 2012 10:42 am Post subject: Re: Help migging alum. |
|
|
We had some wrongly stamped Bernard contact tips that said .045 but were .035 in actuality.
|
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
|
|
Discount Prices for Parts! You can help support this extensive website by purchasing your tractor parts, manuals and merchandise from our [ Antique Tractor Store ] or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
|
YT Home
| Tractor Manuals
| Tractor Parts
| Forum Home
Copyright © 1997-2013 Yesterday's Tractor Co. - A Washington State Corporation
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in