Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

601 Workmaster Power Steering Swap to 850


 
Post new topic    
View previous topic :: View next topic  
Author Message
Rconk
Guest






Report to Moderator

PostPosted: Sun Dec 16, 2012 9:02 am    Post subject: 601 Workmaster Power Steering Swap to 850 Reply to specific post Reply with quote

I have a 1956 850 with bucket loader, standard steering and would like power steering. I have an opportunity to purchase a Workmaster 601 with power steering with bucket loader. Does anybody know if the 601 Power Steering will bolt on and work on my 1956 850.
 
Back to top
Dean
Tractor Guru


Joined: 29 Jan 1998
Posts: 12745


Report to Moderator

PostPosted: Sun Dec 16, 2012 9:28 am    Post subject: Re: 601 Workmaster Power Steering Swap to 850 Reply to specific post Reply with quote

It's a bolt on.

Dean
 
Back to top
View user's profile
old
Tractor Guru


Joined: 12 Mar 2000
Posts: 57391
Location: Lake of the Ozarks area of MO

Report to Moderator

PostPosted: Sun Dec 16, 2012 9:43 am    Post subject: Re: 601 Workmaster Power Steering Swap to 850 Reply to specific post Reply with quote

I read his post a few minutes ago and figured it would work but since I was not sure did not answer him. I will try to remember this so if the need is there I will know
 
Back to top
View user's profile
awhtx
Tractor Guru


Joined: 16 Jan 2002
Posts: 5053
Location: Lampasas, TX

Report to Moderator

PostPosted: Sun Dec 16, 2012 1:39 pm    Post subject: Re: 601 Workmaster Power Steering Swap to 850 Reply to specific post Reply with quote

There is an "ear" with a hole in it that is part of the thermostat housing/water neck. That ear is a mounting bracket for the power steering pump. If your 850 doesn't have it you will need that part off of the 601.
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Ford All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters