Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Ford 801 Powermaster 172 Cubic In block

Post new topic    
View previous topic :: View next topic  
Author Message
10 bluebird
New User

Joined: 17 Dec 2012
Posts: 12

Report to Moderator

PostPosted: Mon Dec 17, 2012 12:41 pm    Post subject: Ford 801 Powermaster 172 Cubic In block Reply to specific post Reply with quote

My tractor threw a rod and I had to get another block. I had a 172 diesel block. The block I got to replace it was Conn6015J. Obviously this was a gas block because when I went to mount my balance gear to mate up with my crank one hole was not bore deep enough and it didn"t have a hole on the other side period. So I took it to the machine shop and they bored and tapped it for me.

I thought my problems were over but when I went to put the head on the bolts do not work, mu block is 5/16s and my old head bolts are 7/16s and the holes that are in the block line up but my head has other holes that are not in the block. Please advise on what I should at this point. If I bore the existing holes from 5/16s to 7/16s and bore additional holes so the head will work, will my rocker arm assembly work valves work right/ etc.?

Thanks Sad
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Ford All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters