Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

What size older Oliver needed?


 
Post new topic    
View previous topic :: View next topic  
Author Message
60 Fan
Regular


Joined: 27 Dec 2006
Posts: 128
Location: Eastern Iowa

Report to Moderator

PostPosted: Fri Dec 21, 2012 8:36 am    Post subject: What size older Oliver needed? Reply to specific post Reply with quote

Inquiring in general what sizes of tractor horsepower/model wise would I need to drive various sizes of 540 PTO generators? How big for instance generator can I power with a 77?
 
Back to top
View user's profile
rrlund
Tractor Guru


Joined: 21 Dec 2006
Posts: 24464


Report to Moderator

PostPosted: Fri Dec 21, 2012 8:42 am    Post subject: Re: What size older Oliver needed? Reply to specific post Reply with quote

I can run my 12,000 just fine with my 66,so I'd think a 77 would handle a 15,000 alright.
 
Back to top
View user's profile
e
Long Time User


Joined: 05 Mar 2009
Posts: 751


Report to Moderator

PostPosted: Fri Dec 21, 2012 9:18 am    Post subject: Re: What size older Oliver needed? Reply to specific post Reply with quote

A 77 is about 35hp at the PTO. This equates to 26kW, but there will be some driveline losses. So, you might be able to run a 20kW generator.
 
Back to top
View user's profile
greg krush
Regular


Joined: 21 May 2011
Posts: 41


Report to Moderator

PostPosted: Sat Dec 22, 2012 4:00 pm    Post subject: Re: What size older Oliver needed? Reply to specific post Reply with quote

it is easier and takes less HP to run an oversize generator at a partial load than to run an undersized at full load. i ran a 25/35 kw with a 77 no problems. however using a 15/20 on the same load would kill the tractor when vacuum pump would kick on.
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Oliver, Cletrac, Coop and Cockshutt All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  

TRACTOR PARTS TRACTOR MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters