Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

2020 Clutch Update

Post new topic    
View previous topic :: View next topic  
Author Message
1 Dollar
Long Time User

Joined: 10 Jun 2005
Posts: 636
Location: Central IN

Report to Moderator

PostPosted: Fri Dec 21, 2012 7:32 pm    Post subject: 2020 Clutch Update Reply to specific post Reply with quote

Finally got the 2 stage clutch back together. Made an aligning tool from a dowel rod and layered masking tape. It fit through the pilot bearing and both clutch plates. Took forever and a day to get the two halves of the tractor aligned and all the splines. Had to jack up the rear tire so I could spin the inner shaft and get it to slide on the splines.

Problem was the fingers were set wrong. Probably didn't need a full split but I learned and she works now! 2 stage clutch!

Back to top
View user's profile
Tx Jim
Tractor Guru

Joined: 14 Feb 1999
Posts: 25049

Report to Moderator

PostPosted: Sat Dec 22, 2012 4:00 am    Post subject: Re: 2020 Clutch Update Reply to specific post Reply with quote

Thanks for letting us know and congratulations.
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> John Deere All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters