Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

496 disc

Post new topic    
View previous topic :: View next topic  
Author Message

Joined: 02 Feb 2011
Posts: 54

Report to Moderator

PostPosted: Sat Jan 12, 2013 10:03 am    Post subject: 496 disc Reply to specific post Reply with quote

I recently bought a set of 496 disk. When you try to fold them
back up only the left side will raise. It will attempt to lift the right
side and if I physically pull up on the wing it will go on and
raise. When you lower them it will raise right back up as long
as you don't let it go all the way down. I speculate that one or
both of the cylinders has an internal leak and is bypassing oil.

Also, what holds the pins in the pivot point where the wing
wheels raise up and down. I can't seem to find and bolts that
hold them in. Almost as if they are pressed in but I can't
imagine that they're pressed in. I want to remove those pins so
I build the pivot point back up and get the play out of it. Any
input is appreciated
Back to top
View user's profile
New User

Joined: 12 Jan 2013
Posts: 1

Report to Moderator

PostPosted: Sat Jan 12, 2013 2:13 pm    Post subject: Re: 496 disc Reply to specific post Reply with quote

The wing wheels pin should have a flat strap welded to the pin with a hole in it bolted to the flat plat the pin goes through
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Farmall & International Harvester (IHC) All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters