Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

John Deere 350C Tach Cable


 
Post new topic    
View previous topic :: View next topic  
Author Message
1970-1655
Regular


Joined: 13 Mar 2009
Posts: 498


Report to Moderator

PostPosted: Sun Jan 13, 2013 2:45 pm    Post subject: John Deere 350C Tach Cable Reply to specific post Reply with quote

Next up on my list of little things to fix on my 1979 350C John Deere is the tachometer cable. I pulled it loose at the tachometer and turned the engine over. Cable never moved. I tried to pull the cable out of the housing to check but it only comes up about 1". How do I go about changing the cable? The engine end is located deep on the rear of the engine and tight to the dash assembly.
 
Back to top
View user's profile
Bob Bancroft
Tractor Guru


Joined: 05 Mar 2009
Posts: 3720
Location: Aurora NY

Report to Moderator

PostPosted: Sun Jan 13, 2013 5:08 pm    Post subject: Re: John Deere 350C Tach Cable Reply to specific post Reply with quote

Many of them have a piece crimped on one end which means they can only come out one way.
I imagine your cable assy. is the old braided steel type. I would replace the whole assy. anyhow.
 
Back to top
View user's profile
farmerscotty
Regular


Joined: 16 Jun 2005
Posts: 108
Location: Ozark, MO

Report to Moderator

PostPosted: Sun Jan 13, 2013 5:42 pm    Post subject: Re: John Deere 350C Tach Cable Reply to specific post Reply with quote

you can buy a generic cable at the auto parts store that might work. Take yours out and see what they have before you go to JD to get one. I have done that on several rigs and works fine.....you cut them to length and crimp an "end" on the cable.
Outside wood furnace forced air system.

 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Crawlers, Dozers, Loaders and Backhoes All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters