Yesterday's Tractor Co.
Shop Now View Cart
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile    Log inLog in 

Round spoke wheel

Post new topic    
View previous topic :: View next topic  
Author Message
Papa Fox

Joined: 17 Mar 2007
Posts: 65

Report to Moderator

PostPosted: Sat Jan 19, 2013 11:49 am    Post subject: Round spoke wheel Reply to specific post Reply with quote

I Have a 9x36 cast in hub rear wheel with casting # ABX 36580. Believe it is an F&H wheel. Cast in hub is broken. Has anyone had any luck with cutting out the cast in center, boring appropriate holes , and using a bolt in hub? Its a nice wheel & would like to save it if possible. Any thoughts or advice?
Back to top
View user's profile

Joined: 13 Mar 2000
Posts: 380

Report to Moderator

PostPosted: Sat Jan 19, 2013 2:19 pm    Post subject: Re: Round spoke wheel Reply to specific post Reply with quote

Yes, It can be done, I have a set of factory flats on a unstyled B that where originally 12 spline and the ears where broke. They have been drilled out with 10 spline bolt in hubs installed. You can't tell when they are on the tractor.
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> John Deere All times are GMT - 8 Hours
Page 1 of 1

Jump to:  

Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]

YT Home  |  Forums

Modern View Forum powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters