Yesterday's Tractor Co. Parts for Farm Tractors - Compare our Prices!
Click Here or call 800-853-2651 
   Allis Chalmers Case Farmall IH Ford 9N,2N,8N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Traditional YT Forum ViewClassic View   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

RD450 transplant


 
Post new topic    
View previous topic :: View next topic  
Author Message
bdpuller
New User


Joined: 08 Jan 2008
Posts: 19


Report to Moderator

PostPosted: Wed Jan 23, 2013 7:34 pm    Post subject: RD450 transplant Reply to specific post Reply with quote

Looking for opinions/suggestions on which tractor to use-460 or 560.
 
Back to top
View user's profile
2-lunger
Guest






Report to Moderator

PostPosted: Thu Jan 24, 2013 5:56 am    Post subject: Re: RD450 transplant Reply to specific post Reply with quote

I used a 560 because of the bigger bell housing so I can use a bigger clutch. There is not much difference in weight if you strip them down but a little how much I'm not sure. If you search RD in a 560 on here you can get all the info you need for the swap.
 
Back to top
AFTERSHOCK
Regular


Joined: 05 Sep 2012
Posts: 24


Report to Moderator

PostPosted: Thu Jan 24, 2013 6:17 pm    Post subject: Re: RD450 transplant Reply to specific post Reply with quote

I would go with the 560. Heavier rear, bigger clutch.

 
Back to top
View user's profile
6 cylinder puller
Guest






Report to Moderator

PostPosted: Fri Jan 25, 2013 3:45 pm    Post subject: Re: RD450 transplant Reply to specific post Reply with quote

did you make your own side shields? and where did you get you scatter blanket? You have a very nice clean looking tractor.
 
Back to top
AFTERSHOCK
Regular


Joined: 05 Sep 2012
Posts: 24


Report to Moderator

PostPosted: Fri Jan 25, 2013 3:51 pm    Post subject: Re: RD450 transplant Reply to specific post Reply with quote

Had a local guy that works with stainless steel make the side shields and the scatter blanket came from Stroud in OK.
 
Back to top
View user's profile
bdpuller
New User


Joined: 08 Jan 2008
Posts: 19


Report to Moderator

PostPosted: Fri Jan 25, 2013 7:30 pm    Post subject: Re: RD450 transplant Reply to specific post Reply with quote

Sweet lookin ride! Thanks for the replies.
 
Back to top
View user's profile
Display posts from previous:   
Post new topic    Yesterday's Tractors Forum Index -> Tractor Pulling All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
TRACTOR   PARTS TRACTOR   MANUALS
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F).  Expedited shipping available, just call!  Most prices for parts and manuals are below our competitors.  Compare our super low shipping rates!  We have the parts you need to repair your tractor.  We are a Company you can trust and have generous return policies!   Shop Online Today or call our friendly sales staff toll free (800) 853-2651.

YT Home  |  Forums Home

Copyright © 1997-2014 Yesterday's Tractor Co.

Powered by phpBB © 2001, 2005 phpBB Group

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters